After changing the Capture Server's IP address, launching any module results in the following error:
"COM error 7001 ACLicClnt: Unable to connect to license server. The license server maybe down or the network may have problems. (the underlying connection was closed: unableto connect to the remote server)"
Changing License server IP address
This error indicates that the clients workstations cannot find the License service on the expected port and IP address. Since most IP address changes coincide with a reboot of the server, it is unlikely that most users will ever see this error. However, some operating systems allow an IP change without a reboot.
Whenever there is a change to the IP address of the Kofax Capture server, the Kofax Capture Service service must be restarted. Restarting the service refreshes the server information and should allow the clients to successfully connect to the License server.
It is also possible that the license service has been disabled in the System Registry.
Open the System Registry and browse to the following Registry Key:
HKEY_LOCAL_MACHINE\SOFTWARE\Kofax Image Products\Ascent Capture Service\Licensing\Licensing Service
or on a 64bit system
HKEY_LOCAL_MACHINE\SOFTWARE\Wow6432Node\Kofax Image Products\Ascent Capture Service\Licensing\Licensing Service
Check the "Enabled" value. If its value is 0, change it to 1, then stop and start the Ascent Capture Service service.
Beside above, verify that the server and workstation exist on the same subnet, This can be checked by comparing results of IPConfig /ALL on a working and non-working machine or by review of the DNS Server addresses of the affected Network Connector.
|NOTE: Before editing the System Registry, be sure to create a backup.|
Level of Complexity
Article # 3031394