Skip to main content
Kofax

MarkView Scan - Barcode recognition improved with Kofax upgrade

Summary

3863

Applies To

  • ERP System: All
  • MarkView Version: 6.4 and earlier

Behavior

  • Barcode recognition is poor using Markview Scan.

Known Causes

  • The most likely cause of bar code recognition problems is poor image quality.

Resolution

  • To ensure the best possible image quality, use the menu settings
  • In some cases recognition rates may be improved by upgrading the Kofax recognition engine installed with every MarkView Scan installation. To see if you can benefit from an upgrade please log a Support Case.
  • The software varies depending on Scanner and Controller models. Please ask for assistance if needed in locating the following required information.
    • MarkView Scan version
    • Scanner Make and Model
    • Either:
      Kofax Controller Board Model
      or
      Kofax USB Dongle Version
    • Kofax Image Controls or VRS version (Run VCDemo and choose Help -> About Image Controls...)
  • Bar_Code_Properties_and_Analysis_Wi_.doc
  • screenshots_markview.zip

Keywords: MarkView Scan, bar code