Skip to main content
Kofax

Patch Code Specification Requirements

2798
3014647

Question / Problem: 

What are the required Patch Code specifications to ensure that the Kofax VRS / ImageControls can recognize a Patch Code?

Answer / Solution: 

Kofax VRS / ImageControls can recognize Patch Codes that meet the following specifications:

 

Patch Code Position:

  • The patch code must be horizontal to the leading edge of the page
  • The top edge of the patch code must be at least 0.20 inches from the leading edge of the page.
  • The bottom edge of the patch code be within 3.75 inches from the leading edge of the page
  • Patch Codes are only recognized on Front-Side images (1st, 3rd, 5th, 7th, 9th, etc. images received from the scanner) when scanning in Duplex mode

 

Patch Code Size:

  • The narrow bars must be 0.08 inch in height
  • The wide bars must be 0.20 inch in height
  • The entire patch code must be 0.80 inch in height
  • The entire patch code must be at least 2 inches wide

 

Patch Code Types:

  • Type I
  • Type II
  • Type III
  • Type IV
  • Type T
  • Type VI

 

 

Applies to:  

Product Version
VRS 4.5
  5.0
  5.1
  5.1.1
  5.1.2
  5.2

 

 

  • Was this article helpful?